NanoVNA-F_V2 is a new generation of portable, stand-alone vector network analyzer with 4.3″ IPS LCD screen, metal enclosure, 5000 mAh battery and SMA
connectors. It is a product based on edy555’s NanoVNA and OwOComm’s S-A-A-V2. The measurement frequency range of NanoVNA-F V2 is up to 3GHz. The S21 dynamic range is greater than 70dB at 50kHz-1.5GHz and greater than 60dB at 1.5GHz – 3GHz. NanoVAN-F V2 can work continuous for 7 hours due to the large capacity battery and low-power design.
Specification
- Frequency range: 50kHz ~ 3GHz
- S11 dynamic range: 50dB(50kHz ~ 1.5GHz), 40dB(1.5GHz ~ 3GHz)
- S21 dynamic range: 70dB(50kHz ~ 1.5GHz), 60dB(1.5GHz ~ 3GHz)
- RF output power: -9dBm
- Frequency tolerance: 0.5ppm
- Screen: 4.3″ IPS LCD, 800*480, RTP touchpad
- Operation via touch screen or 3 side buttons
- Battery: 3.7V Li-Po, 5000mAh
- Aluminum enclosure: 125mm x 75mm x 20mm
- SMA femal RF port
- Sweep points: 101
- Calibration result storage: 5
- Calibration result interpolating supported
- Traces: 4
- Markers: 4
- Measures: S-parameter, VSWR, smith chart, phase, ploar, etc.
- Mark table can be moved up and down
- Firmware upgrade via U-disk with type-c cable
- USB power output: 5V/1A
- Compatible with NanoVNA-saver, support screenshot
PartList
- NanoVNA-F V2 x1
- 20cm SMA-JJ RG405 cable x2
- Calibration kit: SMA OPEN/SHORT/50ohm LOAD
- SMA-KK adapter x1
- SMA-JJ adapter x1
- SMA-JKW adapter x1
- USB Type-C cable x1
- Stylus x1
Scan points increased to 301;
Fixed the bug of directly setting the marker frequency in CENTER/SPAN mode;
Changed the frequency value color of the SAVE/RECALL menu in dark mode;
After upgrading to firmware v0.5.0, the previously saved calibration states will be lost, and you will need to recalibrate the device before measuring
Subscribe to Chelegance channel
